update Updated: 07/11/2018
For the Raise 3D N Series, you will need to print these files, already oriented as needed. Here are a few recommendations for printing:
This is your last print without Zimpure!
Unscrew the right extruder fan of your Raise 3D. Remove the original filament cooling adapter, and replace it by the RaiseSuctionHead.
Use one back to back Velcro tape to tighten the UpperHoseHolder.
Insert the hose into the UpperHoseHolder and in the RaiseSuctionHead.
Plug the hose to Zimpure and here you go, your Zimpure is ready to filter! If you use the RAISE Cover, leave Zimpure into the chamber as shown on the picutre, but use the Cover90Adaptor so the hose will not bend. You need to turn it ON only after than your Raise 3D has started to print. Please verify how the beginning of the first layer goes. You are now all set up to print safely, without any toxic emissions. You can see how Zimpure is efficient by smelling on the top of your Raise. No more bad and hazardous ABS smelt! Happy safe printing!